Foxy Hairclip

If you are anything like me and leave things to the last minute then this hair clip is for you! New Year’s Eve ready in 20minutes or less!

Dig around in your stash and I’m sure you’ll have enough to make a hair piece so you’ll be ready to party in no time!

by Marni Franks

Materials

An assortment of ribbons or lace

Sparkly flowers

Chiffon flowers

Scissors

Ruler

Lighter

Hot Glue Gun and spare gluesticks

Hair clip base/headband

Elastic

20141231_055103

Method

For this hair clip I am using the large black ribbon with white spots, one black chiffon flower and one orange with sparkles flower.

Take the wide ribbon and straighten one end with scissors. Then carefully melt the end with the lighter to seal in the loose threads.

NOTE: Natural fibres like cotton and silk will not melt. Your acrylic and synthetic ribbons will. You might need to test your ribbons first.

20141231_055154

Then carefully start to loop the ribbon, starting with a big loop.

20141231_055229

Use the hair clip to find the best position for the loops to sit.

20141231_055245

Keep making loops, making them a little smaller each time. Three loops in total.

20141231_055258

20141231_055310

Remove the clip base and start to carefully glue the loops together.

20141231_055405

Turn the looped section over and find the position for the hair clip base again.

20141231_055547

Run a line of glue inside the ribbon and secure the hair clip base to the ribbon, so that the top part of the clip sits as shown in the below photo and doesn’t get glued down.

20141231_055550

Turn the hair clip over.

20141231_055608

Trim up the chiffon flower – many come with a net backing.

20141231_055648

Place a small amount of glue in the centre of the back of the flower.

20141231_055704

Place the flower so that it covers the remaining part of the hair clip base but does;t sit directly on it.

20141231_055719

20141231_055740

Flatten the chiffon flower petals out.

20141231_055749

Place a small amount of glue on the back of your small orange flower with sparkles.

20141231_055756

Glue the orange flower in the centre of the flattened black flower.

20141231_055808

20141231_055824

Turn the hair clip over and fold up the end of the black spotty ribbon, trim it as shown in the middle of the hair clip.

20141231_055900

Melt the end of the cut ribbon and run a line of glue along the end.

20141231_055938

Fold the ribbon across the back of the hair clip and glue down (avoid the base).

20141231_055954

Gently ease the hair clip base out from under the ribbon.

20141231_060006

Glue down any spots of the ribbon that seem a bit puffy or loose.

20141231_060015

Take a small length of contrasting ribbon – orange or white.

Cut the ends at an angle and melt with the lighter.

20141231_060104

Make a small bow and glue to the middle of the hair clip, just under the centre of the flowers.

20141231_060211

Clip in your hair and you are ready!

20141231_060229

HAPPY NEW YEAR

from the 55FF team!

Mel, Dawn and myself would like to thank you for joining us this year. We hope you’ve had fun and made lots of exciting goodies. We are taking January off and will be back here in February with a different approach to the foxy goodness that we’ve shared so far.

55FoxFiasco

1920s inspired fascinators

by Marni Franks

With Melbourne Cup next week here’s some fascinators you can whip up in no time at all!

Materials for black headband

20cm (8in) black net or tulle

60cm (24in) of 25mm (1in) black elastic

10cm (4in) of 120mm (5in) black fringing

6 black biot feathers 17cm (7in)

50mm (2in) diamanté buckle

Tools

Hot glue gun and glue sticks

Sewing machine

Hand sewing needle

Black thread

Tape measure

Assembly

Measure around your head where you want the headband to sit. From that measurement minus 2-3cm and cut the 25mm black elastic to size. Using you sewing machine and overlapping the ends of the elastic, stitch in a square sealing all sides of the elastic.

Fold the ends of the 10cm of black fringing back to hide the raw edges, and stitch it to the elastic centering it over the join.

With the 20cm of black tulle, fold it in half matching the selvedges. Fold in half again and gently scrunch it up. Thread one end of the tulle through the 50mm diamanté buckle, and slide the buckle into the centre to make a bow.

Using the hot glue gun, glue the 6 biot feathers to the back of the buckle/bow and allow the glue to cool.

Once the glue is cool hand sew the bow/buckle/feathers to the elastic centring it over the fringing.

 Your headband is ready to wear.

20141028_093420

Materials for colourful headband

15cm (6in) cerise chiffon

7cm (3in) sequined motif

60cm (24in) 25mm (1in) elastic lace

3, 17cm (8in) teal tiger tuft feathers

5, 12cm (5in) purple tiger tuft feathers

Tools

Hot glue gun and glue sticks

Sewing machine

Hand sewing needle

Black thread

Tape measure

Assembly

Measure around your head where you want the headband to sit. From that measurement minus 2-3cm and cut the 25mm black elastic to size. Using you sewing machine and overlapping the ends of the elastic, stitch in a square sealing all sides of the elastic.

Lengthen the straight stitch on your machine and sew 1/4in from one raw edge of the cerise chiffon a running stitch. Tie off one ends threads in a reef knot. Pulling the bobbin thread gently gather the chiffon into a circle. Bunch up the edges and hand-sew them into the centre making a rough heart shape.

Hand-stitch the chiffon to the join on the lace elastic.

Using the hot glue gun glue the 3 teal feathers onto the chiffon – one in the centre and one to either side of the centre. Then glue the 5 purple feathers on in the same manner, using the photograph as a guide. Finally glue the sequined motif over the ends of the feathers making sure the narrowest point of the motif is facing up.

Allow the glue to cool and your headband is ready to wear.

20141028_093651

Flossy’s Lava Lamp Champers

by Mel Alce

Add a sugary touch to your next drink of champers – and watch the chemical reaction!

Ingredients

Fairy Floss

Champagne

Food colour – optional

  2014-09-18 14.29.22

Method

Place fairy floss into your drinking vessel of choice (glass, flute, bucket).

2014-09-18 14.33.40

Squeeze a few drops of your food colour of choice.

Pour champagne into the glass, slowly as the fairy floss will make it fizz more than normal.

2014-09-18 14.33.53 2014-09-18 14.34.06 2014-09-18 14.34.17 2014-09-18 14.34.28 2014-09-18 14.35.51 2014-09-18 14.35.56

Drink!

2014-09-18 14.38.13 2014-09-18 14.39.22

The Fizzy Fox

By Mel Alce

Ingredients

6 heaped tblsp icing mixture
¾ tsp bi-carb soda
85g pack of orange jelly crystals
½ tsp citric acid
½ tsp tartaric acid
1 shot Bacardi per cocktail (or your personal favourite clear spirit)
Fanta
Ice

Fizzy Fox 1 ingredients

Preparation

Place the Fanta in the fridge, or put it in a jug on ice.

Method

Sherbet
Mix citric acid, tartaric acid & icing mixture until well combined.
Add jelly crystals and mix well.
Place the sherbet mix onto a plate (make sure the plate is bigger than rim of your cocktail glass).

Fizzy Fox 2 Sherbet

Put some cold water into a bowl (slightly bigger than the rim of your glass).
Dip the glass into the water and let the excess drip back into the bowl.

Fizzy Fox 3 water dip

Dip the wet rim of the cocktail glass into the sherbet.
Repeat the dipping process for all glasses.

Fizzy Fox 4 sherbet dip

Wipe any dripping water that may have escaped the ring of sherbet, with a clean cloth.
Pour one shot of Bacardi (or other spirit) into the glass.

Fizzy Fox 5 sherbet ring

Top up the glass with Fanta.

Fizzy Fox 6 enjoy

Sip & enjoy!

OPTION 1: For a virgin Fizzy Fox, you can just have straight Fanta, or mix it up with some lemonade or lemon squash.
OPTION 2: Red Fizzy Fox – replace Fanta with Creaming Soda, and orange jelly crystals with raspberry or strawberry jelly crystals.
OPTION 3: Arctic Fizzy Fox – replace Fanta with Lemonade, and orange jelly crystals with Lemonade jelly crystals.